BarcodeYes BLASTER Uživatelský manuál stáhnout pdf (Strana 18)

- 18 -

2.4

Character Installation

The first and last character: You can put 10 ASCII at

most in front of the barcode data. When the

installation is “0” that means you don’t need to add the

first and last character. Please find the format as

below:

The First Character Barcode The Last Character

The process for adding the first and last character to

the barcode:

1. Scan the barcode of “Start Configuration” and

“The First Character Installation”.

2. Check the ASCII table to get the ASCII code of

the first and last character.

3. Scan the barcode of ASCII in the Appendix.

4. Scan the “End Configuration”.

G1/G2 character Insertion: You can put 10 ASCII at

most in front of the barcode data. When the

installation is “0” that means you don’t need to add the

first and last character.

1. Scan the barcode of the “Start Configuration” and

“G1 Insert Character”.

2. Check the ASCII table to get the ASCII code of

the first and last character.

3. Scan the barcode of ASCII in the Appendix.

4. Scan the “End Configuration”.

5. Repeat the same process to the G2 insertion.

6. Scan the “End Configuration”.

The position of G1/G2 character insertion: To select a

character insert to the barcode. You can’t insert any

character while the installation is “0”

1. Scan the barcode of the “Start Configuration” and

“G1 character insertion position”

2. Check the ASCII table to get the corresponding

ASCII code of the insertion position.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Žádné komentáře

BarcodeYes BLASTER Uživatelský manuál Strana 18